Prediction Of The Dew-Point Pressure Of A Gas Condensate Reservoir

  • : Ms Word Format
  • : 82 Pages
  • : ₦3000
  • : 1-5 Chapters
  •  
  • Click to DOWNLOAD Materials
PREDICTION OF THE DEW-POINT PRESSURE OF A GAS CONDENSATE RESERVOIR

TABLE CONTENTS

Title Page———i

Certification——–ii

Dedication———iii

Acknowledgement——-iv

Abstract ———vi

Table of Content——–vii

 

Chapter One

1.0 Introduction ——-1

1.1 Statement of Problem——4

1.2 Purpose of the Study——5

1.3 Significance of Study——8

1.4 Limitation——–9

1.5 Scope of Study——-11

 

Chapter Two

2.0 Review of Related Literature —-12

2.6 Summary of Literature Review—- 19

 

Chapter Three

3.0 Research Methodology and Procedure—22

3.1 Population ——–22

3.2 Sample and Sampling Technique—-22

3.3 Validation of the Instrument —-23

3.4 Reliability of the Instrument —–23

3.5 Data Analysis——-23

 

Chapter Four

4.0 Presentation and Discussion of Result—24

4.1 Analysis and interpretaion of Data—25

4.2 Discussion of Results——38

 

Chapter Five

5.0. Summary, Conclusion, and Recommendation  –40

5.1 Summary——–40

5.2 Conclusion——–41

5.3 Recommendation——42

References ———45

Appendix 1——–47

Appendix ———50

 

CHAPTER ONE

INTRODUCTION

 1.1      Background of study

Gas Condensate Reservoiris a reservoir having low-density mixture of liquid hydrocarbons that are present as gaseous components in the subsurface (in the reservoir). It is important to recognize that some gas condensate reservoirs show condensate dropping out within reservoirs, as well as condensate production at the surface due to pressure falling below the dew-point during production. This condensate accumulation in the reservoir initially remains immobile due to interfacial forces between it and connate water within the pores of the formation until its saturation level reaches a threshold value and becomes mobile.

Initially, the gas-condensate is totally gas in the reservoir. As reservoir pressure decreases, the gas condensate exhibits a dew-point. The dew-point of a gas condensate fluid occurs when a gas mixture containing heavy hydrocarbon is depressurized until liquid is formed, that is, a substantial amount of gas phase exists in equilibrium with an infinitesimal amount of liquid phase. A pressure is reduced; liquid condenses from the gas to form free liquid in the reservoir. Normally, there is no effective permeability to this liquid phase and it is not produced. If the pressure continues to decrease, a second dew-point will be reached and the liquid can be re-vaporized. This lower dew-point pressure is usually well below the reservoir abandonment pressure; thus it would be of no interest in reservoir performance.

By definition, dew-point pressure is simplythe pressure at which an infinitesimal amount of liquid is in equilibrium with a large quantity of gas. the pressure below which liquid condense out of the gaseous phase.

A phase behaviour can be defined as the characteristics (changes in phase) exhibited by the gas when subjected to different temperature-pressure conditions.

During production, the hydrocarbon molecules undergo various phase and some property change, altering intermediate stages which are crucial in designing and operating the processes efficiently and optimally.

Unlike a pure substance that has both bubble-point and dew-point the same at a particular temperature and pressure, a gas condensate reservoir is a multi-component system thus at a particular temperature and pressure, each component present, exhibit their different characteristics. This is because the natural gas reservoir is not an ideal mixture. This can be seen clearly in fig 1.1.

 

Figure 1.1, Phase behaviour of Gas condensate reservoir by Li Fan, College Station, Texas, USA.

1.2       Problem statement

Condensate liquid saturation usually build up near a wellbore area because of drawdown below the dew-point pressure, ultimately restricting the flow of gas. The near-well choking can reduce the productivity of a well by a factor of two or more. The phenomenon called condensate blockage or condensate banking, results from a combination of factors, including fluid phase properties, formation flow characteristics and pressures in the formation and in the wellbore. If these factors are not understood at the beginning of field development, sooner or later production performance can suffer. This condensate blockage is a major challenge in the oil and gas sector since production rate is reduced. Therefore, the dew-point pressure at which this formation occurs needs to be accurately predicted in order to reduce reservoir damage caused by condensate blockage and thus increase production rate.

1.3       Aim and objectives

1.31    Aim

To improve the prediction of the dew-point pressure of a gas condensate reservoir.

1.32    Objectives

  • Generation of gas condensate data
  • Generation of a new mathematical correlation to accurately predictdew-point pressure

1.4       Significance of work

Every day, the petroleum industries are producing fluid from the condensate reservoirs in order to satisfy human and industrial needs. It is of great concern on the path of production and reservoir engineers to make sure the dew-point pressure of a gas condensate reservoir is accurately known.

As described earlier, the condensate reservoirs when produced below dew-point pressure tends to release liquid which reduce formation permeability and thus reduce production rate.

For example, well productivity in the Arun field, in North Sumatra, Indonesia, declined significantly about 10 years after production began. Well studies, including pressure transient testing, indicated the loss was caused by accumulation of condensate near the wellbore.

Therefore, this article focuses on the prediction of the dew-point pressure of a gas condensate reservoir so that production and reservoir engineers can be aware and produce gas condensate reservoirs optimally.

1.5       Scope of work

The scope of this project is limited to developing a mathematical correlation that would be used to accurately predict the dew-point pressure of a gas condensate reservoir using data from literature.

 

GET MORE: OIL AND GAS, PETROLEUM ENGINEERING PROJECT TOPICS AND MATERIALS  PREDICTION OF THE DEW-POINT PRESSURE OF A GAS CONDENSATE RESERVOIR

Leave a Reply